Maintain the horizontal motion of the AL2O3 stick while dressing.

Check the cut size at the cutting station a maximum of 0.5mm per side.

Dress with an AL2O3 stick.

Check the rpm of the wheel so as the maintain a peripheral speed of 45-50 m/s.

If no effect, consult with the wheel manufacturer for correct diamond-bond matrix for the specific application.

Make sure that the frequency of dressing has not increased, and the grit size of the AL2O3 stick is of the same size or one size finer than the diamond mesh size.

If no effect, consult with the wheel manufacturer for correct diamond-bond matrix for the specific application.

Check if the wheel mounting procedure and the star-up procedure are followed.